毕业设计---手柄注射模设计

《毕业设计---手柄注射模设计》由会员分享，可在线阅读，更多相关《毕业设计---手柄注射模设计（39页珍藏版）》请在毕设资料网上搜索。

1、 20112011 届毕业设计说明书届毕业设计说明书 手柄注射模设计 系 、 部： 机械工程系 摘 要 本文阐述了电水壶手柄注射模设计的过程。 首先， 对塑件进行工艺性分析后， 利用 Pro/e 参数化三维实体造型软件完成塑件的三维造型。然后，通过分析确定 塑件的分型面、最佳浇口等。本模具采用了一模两腔及侧浇口等结构。该课题从 产品结构工艺性、 具体结构模具出发， 对模具的浇注系统、 模具成型部分的结构、 顶出系统、冷却系统、注塑机的选择及有关参数的校核等都有详细的设计。通过 整个设计过程表明该模具能够达到此塑件所要求的加工工艺。此外，设计中还采 用了斜导柱侧向抽芯机构。在模具成型零件设计方面

2、，设计中对成型零件的机构 和尺寸进行了合理的考虑和计算。最后，设计还包括零件图和装配图的绘制。 关键词 ： 注射模;手柄;侧浇口;侧向抽芯 ABSTRACT This paper expounds the electric kettle handle injection mould design process. First of all, on the craft of plastic parts after analysis and Pro/e parameterized using three-dimensional modelling software plastics three-d

3、imensional modelling. Then, through the analysis to identify the plastic parts parting surface, best runner, etc. This mould adopts a mold two cavity and side gate structure. This topic from product structure manufaturability and specific structure of mould, starting the mould casting system, the st

4、ructure of its molding part, ejection system, cooling system, the injection molding machine selection and relevant parameters such as checking of detailed design. Through the whole design process shows that the mold can achieve the required plastic parts processing. In addition, design also adopted the oblique guide pin lateral core-pulling mechanism. In its molding part design, design of molding parts institutions and size the reasonable consideration and calculation. Finally, design al