道路毕业设计--二级公路B段线路进行设计
《道路毕业设计--二级公路B段线路进行设计》由会员分享,可在线阅读,更多相关《道路毕业设计--二级公路B段线路进行设计(66页珍藏版)》请在毕设资料网上搜索。
1、 I 摘 要 本次设计主要是泉州二级公路 B 段线路进行设计,设计的内容主要包括 选线、平面设计、纵断面设计、横断面设计、超高设计、挡土墙设计、沥青 混凝土路面设计。 为了经济适用,本次设计路基宽度为 14m,土路肩 0.5m,为了保障排水, 路面路拱度 2%,土路肩为 3%。路堤处设边坡,比例 1:1.5,路堑处设边沟, 边沟坡度 1:1,高度和深度均为 0.5m,在深挖的路段另设截水沟截水沟,截 水沟坡比、高度和深度同边沟一致。路面采用沥青混凝土路面,又由于该路 路面等级高,所承受交通量较重,因此采用三层式结构,即表面层采用 4cm 厚的细粒式密集配沥青混泥土, 中面层采用 5cm厚中粒式
2、密集配沥青混泥土, 下层面采用 6cm厚粗粒式密集配混泥土。 关键词 泉州二级公路 选线 沥青混泥土 II Abstract This design is mainly quanzhou secondary roads B section routes for the design, the design of content mainly includes route, graphic design, alignment design, cross-sectional design, ultra-high design, retaining wall design, asphalt conc
3、rete pavement design. In order to economy applicable, the design of roadbed width to 14m, dirt road shoulder 0.5 m, in order to ensure drainage, paving road arch degrees 2%, dirt road shoulder for 3%. Embankment slope, proportion in a 1-1. 5, cutting place set ditches, ditches slope 1:1, height and
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中设计图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- 道路 毕业设计 二级 公路 线路 进行 设计
