机械外文翻译--一个使用四个液体系统分析盘式制动器的制动效率的实验

《机械外文翻译--一个使用四个液体系统分析盘式制动器的制动效率的实验》由会员分享，可在线阅读，更多相关《机械外文翻译--一个使用四个液体系统分析盘式制动器的制动效率的实验（21页珍藏版）》请在毕设资料网上搜索。

1、 PDF外文：http:/ 4570 汉字， 3380 单词， 1.6 万英文字符  出处 :Research Journal of Applied Sciences, Engineering and Technology 5(4): 1302-1308, 2013    本科毕业论文  外文文献及译文   文献、资料题目 ： An Experimental Analysis of Brake Efficiency Using four Fluids in a Disc Brake System  文献、资料来源 ： Research

2、 Journal of Applied Sciences 文献、资料发表日期： 2012.08.08 院（部）： 机电工程学院  专业：  班级：  姓名：  学号：  指导教师：  完成日期：  1 外文文献 ：   An Experimental Analysis of Brake Efficiency Using four Fluids in a Disc Brake System SD Oduro， PO Ansah， A Agyamang ABSTRACT The paper studies disc b

3、rake failure in Mini-buses using an experimental analysis to test the maximum braking force when different brake fluids such as clean, less dirty, dirty and soapy water solution were used in the braking system. The experimental results clearly showed that the soap solution appears to be the best flu

4、id as far as low viscosity and stability of viscosity with increase in temperature are concerned. However, the soap solution is not compatible with other fluid which makes it difficult to be substitute as a clean brake fluid. The result of the Thepra Universal Brake Testing Equipment used for the br

5、aking efficiency test indicated that a pedal brake of 117 kN produce a brake force of 0.96 kN for clean brake fluid, 0.91 kN for the less dirty, 0.85 kN for dirty and 1.44 kN for soap solution. The value of 1.44 kN which was achieved when the soap solution was used indicated a positive braking force

6、 and the indicating that soap solution could be used to produce a high pedal force within a very short time (about 10-30 min) and can therefore be used only in case of emergency. The brake efficiency test indicated that under hot conditions the braking efficiency is reduced and the presence of air i

7、n the system renders the braking ineffective because higher pedal force was needed to be able to produce a significant braking force which is noted for causing brake failure. Keywords: Brake fade, brake failure, disc brake, efficiency, pedal force INTRODUCTION When a vehicle is accelerated, energy s

8、upplied by the engine causes the vehicles speed to increase. Part of this energy is instantly used up in overcoming frictional and tractive resistance but a large amount of it remains stored in the vehicle. According to Heinz (1999) this energy of motion is called the kinetic energy and the existenc

9、e of kinetic energy is observed when a vehicle is moving and neutral gear is selected. The vehicle does not immediately come to rest； instead it travels for a considerable distance before it becomes stationary. In this case the stored energy is used to drive the vehicle   2 against the resistan

10、ces that oppose the vehicles motion. Relying on these resistances to slow down a vehicle could cause many problems, so an additional resistance called a brake is needed to convert the kinetic energy to heat energy at a faster rate in order to reduce the speed of the vehicle Mcphee and Johnson (2007)

11、. This reduces the speed of the vehicle at a faster rate and brings the vehicle to rest within the shortest possible time when the brakes are applied.   From the point of view of Johnson et al. (2003) most automotive systems in use today utilize front disc brakes, but four-wheel disc systems ar

12、e also common In disc brakes, the rotor rotates with the wheel and the pads move out to rub the rotor when the brakes are applied. Most disc brakes use floating calipers. The caliper slides in and out as the brakes are applied and released. The piston moves the inside pad out and pushes the outside

13、pad into the rotor by sliding the caliper back toward the rotor. The use of disc brakes to reduce speed or bring the vehicle to rest when in motion cannot be over emphasized if the safety of the occupant is to be guaranteed Heinz (1999). To bring a vehicle to a stop, the disc brakes have to absorb a

14、ll the energy given to the vehicle by the engine and that due to the momentum of the vehicle. This energy must then be dissipated. In most vehicle disc brakes, the energy is absorbed by friction, converted into heat and the heat dissipated to the surrounding air (Thoms, 1988). As the energy is absor

15、bed, the vehicle is slowed down； in other words, its motion is retarded. The brakes must also pull up the vehicle smoothly and in a straight line to bring the vehicle to a stop position.   It is therefore very important that the disc brakes of vehicles  operate with the highest efficiency.

16、 This could   reduce the rate of accidents due to brake failure so that life and property could be preserved and also to ensure that occupants of these commercial vehicles go about their normal lives without any fear of being involved in an accident. Available crash data in Ghana suggests that

17、about 1,900 persons are killed annually in road traffic crashes (Afukaar et al., 2008) and that more than 40% of the road traffic fatalities are occupants of cars, buses and trucks. Most often than not, some of the road accidents involving commercial vehicles, such as the mini-buses have been attributed to the failure of the disc brakes. The reason for testing the viscosity of these brake fluids, especially that of the