毕业设计---遥控器后盖注塑模具设计

《毕业设计---遥控器后盖注塑模具设计》由会员分享，可在线阅读，更多相关《毕业设计---遥控器后盖注塑模具设计（44页珍藏版）》请在毕设资料网上搜索。

1、 I 遥控器后盖注塑模具设计 摘要 本论文以电视遥控器后盖的注塑模具设计为主要内容， 详细介绍了注塑模具 设计的一般流程，其中的设计内容有零件的工艺性编制：塑件的工艺性分析、塑 件的体积和质量计算及注射机参数的确定； 结构设计： 分型面选择、 型腔数确定、 型腔的排列方式、 浇口设计、 侧向分型抽芯机构设计、 推出及复位机构方式确定； 型芯、型腔尺寸计算；模具加热和冷却系统计算；模具闭合高度确定；注射机有 关参数的校核； 如此设计出的结构可确保模具工作运用可靠。最后对模具结构与注射机的匹 配进行了校核。并用 autoCAD 绘制了一套模具装配图和零件图。 关键词：遥控器，注塑模具，浇注系统，分

2、型面，型腔，型芯关键词：遥控器，注塑模具，浇注系统，分型面，型腔，型芯 II REMOTE CONTROLLER DESIGN OF INJECTIONG MOULD FOR REAR COVER ABSTRACT In this thesis, the TV remote control on the back cover of injection mold design for the main content，Introduces the injection mold design process，Plastic Injection the design process, which i

3、s designed as part of the craft-oriented establishment : Plastic Parts of the Process Analysis, Plastic Parts of the size and quality of calculation and the injection parameters set; Structural design : Surface choice cavity determination, Cavity the arrangement, gate design, lateral type pulling me

4、chanism design, launch and reattached body identified; Core, Cavity size calculation; Die heating and cooling system computation; Mold closing high set; Injection machine parameters in the verification; The design of such a structure can be used to ensure reliable die. Finally, the injection mold structure and the matching machine was calibrated. Using a set of auto mapping mold parts and assembly plans. KEYWARDS：rmote control, injection mold, pouring system, the parting surface, the cavity,