毕业设计---逆变器的设计

《毕业设计---逆变器的设计》由会员分享，可在线阅读，更多相关《毕业设计---逆变器的设计（47页珍藏版）》请在毕设资料网上搜索。

1、 I 逆变器的设计 摘 要 本文中主要介绍了小功率逆变器的设计，其主要包括两部分电路，一是主电路，另 一个是控制电路。主电路主要包括：三相全桥电路,驱动电路；控制电路主要包括：单片 机控制回路，SPWM 波形发生电路，死区保护电路等。在主电路中，全桥逆变电路采用 快速 MOS 管 6N60A；驱动电路采用集成芯片 IR2130；控制回路中采用 STC89C51 单片 机，数模转换采用 AD7528 芯片。逆变电路拓扑结构采用三相全桥逆变，应用电路仿真 软件 Multisim 对电路各部分进行实验仿真，对电路各部分参数选择进行理论分析，利用 51 系列单片机编写程序。最终设计出频率可调整，输出电

2、压可以调整的逆变器。 关键词：SPWM，单片机，IR2130，AD7528 II The design of the inverter ABSTRACT This article introduces a small power inverter design, which mainly includes two parts of the circuit.first, the main circuit, and the other is control circuit. The main circuit include: three-phase full-bridge circuit, dri

3、ver circuit; control circuit including: MCU control circuit of SPWM waveform generating circuit, the dead zone protection circuit. In the main circuit, the full-bridge inverter circuit with a fast MOS transistor 6N60A; driver circuit uses integrated chip IR2130; control circuit used in the MCU STC89

4、C51. AD7528 chip, digital to analog conversion. Inverter circuit topology of three-phase full-bridge inverter, the application circuit simulation software, Multisim to experiment with the various parts of the circuit simulation, theoretical analysis of circuit parameters selection, the use of 51 series microcontroller programming. The final design of the inverter frequency to adjust the output voltage can be adjusted. KEY WORDS: SPWM，MCU，IR2130，AD7528 III 目 录 摘要