一阶倒立摆双闭环模糊控制毕业论文(含外文翻译)
《一阶倒立摆双闭环模糊控制毕业论文(含外文翻译)》由会员分享,可在线阅读,更多相关《一阶倒立摆双闭环模糊控制毕业论文(含外文翻译)(45页珍藏版)》请在毕设资料网上搜索。
1、 1 摘要 本文讨论基于鲁棒性设计的一阶倒立摆双闭环控制问题。以摆角为内环.以 小车位置为外环利用鲁棒孔子系统理论进行模糊控制器设计及参数整定, 使控制 系统对于确定系统参数的变化具有较强的鲁棒性。 倒立摆系统的高阶次、 不稳定、 多变量、 非线性和强耦合等特性使得许多现代控制理论的研究人员一直将它视为 研究对象。论文首先介绍了模糊系统的理论基础,和模糊控制器的分析和设计, 充分的理解了倒立摆智能控制系统研究与设计所需要的理论知识。 然后通过对倒 立摆系统的分析建模,采用模糊推理系统,设计相应的模糊控制器,对倒立摆进 行控制,最后将控制过程在 MATLAB 上加以仿真。在 MATLAB 仿真中
2、,应用 模糊逻辑工具箱来设计模糊逻辑控制器,然后通过 Simulink 来建立模糊系统, 最后得到仿真结果。 关键词:倒立摆,模糊控制,双闭环模糊控制器,MATLAB 仿真。 2 ABSTRACT This article discusses the question of inverted pendulum double loop control that based on robust design. Take the pivot angle as the inner ring , the car position as the outer ring, Carries on the fuz
3、zy controller design and the parameter installation by use robust control system theory, enable the control system to have strong robustness that determine changes in system parameters. As the inverted pendulum system is unstable,multivariable, nonlinear and strongly coupling and so on, many modern
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中设计图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- 一阶 倒立 闭环 模糊 控制 毕业论文 外文 翻译
