eda课程设计--洗衣机控制电路
《eda课程设计--洗衣机控制电路》由会员分享,可在线阅读,更多相关《eda课程设计--洗衣机控制电路(21页珍藏版)》请在毕设资料网上搜索。
1、 课课 程程 设设 计计 说说 明明 书书 课程设计名称:课程设计名称: EDA 技术课程设计 题题 目:目: 洗衣机控制电路 摘要摘要: :从课程设计要求来看,要求实现洗衣机的正转,反转,待机,当显示时间 前 5S 时,正转 60S,待机 5s,反转 60s,如此一来周期就是 130 秒,并用三个 LED 灯和 7 段显示器分别表示其工作状态和显示相应工作状态下的时间。本设计 采用 EDA 技术, 通过 FPGA 芯片实现了洗衣机控制电路的设计, 本文采用 Verilog 硬件描述语言洗衣机控制电路,完成对电路的功能仿真。洗衣机控制电路包括控 制电路, 控制对象, 状态显示电路, 计时及报警
2、电路。 控制器是系统的核心部件。 它是一闭环系统,内部结构有 5s 和 60s 信号产生器、状态计数器、数据选择器 和状态译码器,它能自动发出顺序循环控制信号(S、R、L) ,并同时完成在该状 态下计时功能。 关键词:关键词:EDA 技术、FPGA 芯片、硬件描述语言、控制器、7 段显示器 Abstract:Abstract: From the curriculum design requirement to see, demanding the washing machines are turning, reverse, standby, when shows the time before
3、 5 S, are turning 60 S, standby 5 S, 60 S, reverse, So cycle is 130 seconds, and three LED lamp and seven segment display said its working status and respectively corresponding work condition of that time. Design by EDA technology, through the FPGA chip realized the washing machine control circuit d
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中设计图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- eda 课程设计 洗衣机 控制电路
