毕业设计--电视遥控器外壳本体塑料模具设计与制造

《毕业设计--电视遥控器外壳本体塑料模具设计与制造》由会员分享，可在线阅读，更多相关《毕业设计--电视遥控器外壳本体塑料模具设计与制造（37页珍藏版）》请在毕设资料网上搜索。

1、 I 电视遥控器外壳本体塑料模具设计与制造上壳体模具 设计说明书 摘 要 本文主要介绍了电视机遥控器上壳体塑料模具设计与制造， 根据 ABS 塑料成 型的工艺特性和产品的使用要求，对产品进行详细的工艺分析，在设计工作前进 行大量的资料搜集汇总，然后开始着手于模具设计。其中包括利用 UG 软件对电 视遥控器上壳体进行了三维造型并通过零件造型设计了一副合理尺寸的一模二 穴注塑模具，同时对工件进行工艺分析、注塑机的选用和校核、模具设计和型腔 的排布，浇注系统的设计和模具总体结构，完成一套完整的模具设计过程。 关键词关键词：塑料模具 电视遥控器上壳体 工艺性能 设计过程 II TV remote sh

2、ell ontology on the plastic mold design and manufacturing - Shell mold design specification Abstract TV remote control is mainly introduced in this paper on the shell plastic mold design and manufacturing, according to the ABS plastic molding process characteristics and product requirements, a detai

3、led technical analysis was carried out on the products, before the design work for a huge mass of data gathering, and then start to mold design. Including the TV remote control on the shell by using UG software for 3D modelling and design through parts of a reasonable size one module and two cavity

4、injection mold, at the same time process analysis was carried out on the workpiece, the selection of injection molding machine and check, mould design and configuration of cavity, mold designing and overall structure of gating system, to generate a complete set of mold design process. Key words：Plastic mould ; the shell of the TV remote; Process performance; the design process III 目 录 1.绪论 1 1.1 模具工业概况 1 1.2 我国塑料模具工业和技术现状及地区分布 2 1.3 我国塑料模具工业和技术今后的主要发展方向 3 2.塑件分析 4 2.1 产品的零件图 4 2.2 塑料成型工艺性能