毕业设计说明书----智能红外测温计总体电路设计

《毕业设计说明书----智能红外测温计总体电路设计》由会员分享，可在线阅读，更多相关《毕业设计说明书----智能红外测温计总体电路设计（63页珍藏版）》请在毕设资料网上搜索。

1、毕业设计（论文）说明书 I 摘要摘要 传统的温度计多采用物理原理， 根据水银等随温度升降的热胀冷缩的 性质，通过读取刻度值来判断温度值，这种方法不太方便，且测量需要的 时间较长。本项目提供一种新的温度测量方案，采用具有 SPI（Serial Peripheral Interface 串行外围接口）接口的 TN 系列红外温度传感器来 测量温度信号，可同时测量目标温度和环境温度，并将测量的数据送给 SPCE061A 单片机处理，之后送数码管显示，同时利用 SPCE061A 单片机的 语音功能播报温度值。红外测温打破了传统的测温模式，它响应快、测量 精度高、可靠性高、范围广，为非接触测量，因而不易损

2、坏。该温度计以 其准确快捷的测量功能、清晰易懂的数字化显示方便人们日常生活使用， 语音播报功能使其更加智能化、人性化。 关键词关键词：红外测温；SPCE061A 单片机；语音播报 毕业设计（论文）说明书 II A Design of Intelligent Infrared Thermometer Abstract Most of the traditional thermometers adopts mercury column which has the physical principle that it expands with heat and contracts with cold

3、 along with the change of temperature, and we can read the temperature out according to the infinity. This method is not convenient, and it takes a long time to measure. This paper proposes a new thermometer project to measure the temperature signal by using the TN series infrared temperature sensor

4、 which has the SPI (Serial Peripheral Interface). The sensor can measure both the target temperature and environment temperature at the same time, meanwhile the temperature data which have been measured can be transferred to the SPCE061A microcontroller to process. Then, the data will be transferred to data display, and will be reported by using the SPCE061As voice report function in the meanwhile. Infrared thermometer breaks through traditional temperature measurement pattern. It responses q