毕业设计---新型三相内循环生物流化反应器

《毕业设计---新型三相内循环生物流化反应器》由会员分享，可在线阅读，更多相关《毕业设计---新型三相内循环生物流化反应器（66页珍藏版）》请在毕设资料网上搜索。

1、 I 摘摘 要要 本课题引进流化态技术开发了一种新型三相内循环生物流化反应器，将反应器设计 成三个区，即升流区、降流区和沉淀区。载体与废水在升流区通过曝气流化，在升流区 和降流区内循环移动并完成生化反应，使废水得到净化，泥水在沉淀区分离。 试验采用轻质多孔性泡沫海绵为微生物载体，空隙率 90%，比表面积 2375m2/m3， 挂膜后比重略大于水，易于流化。投放于反应器后，可使污泥浓度达 8000mg/L 以上， 提高流化反应器的容积负荷，可达 12kgCOD/m3 d。 沉淀区为变截面，上升流速减小，污泥絮凝沉降，在重力和循环流抽吸的作用下自 动回流。 三相内循环生物流化反应器为一体化装置，具

2、有结构紧凑、高宽比小、污泥产率低 和动力消耗省等优点，可用于处理中小规模城镇生活污水和工业废水，工艺流程简单， 处理效率高；也可改造原有的处理构筑物为三相内循环生物流化反应器，提高处理能力 和处理效果。因此三相内循环生物流化反应器是一种有发展前景的废水处理工艺。 关键词：三相内循环生物流化床；屠宰废水；曝气器；生物膜；水力停留时间 II ABSTRACT This article empoldered a new reactorThree Phase Inter-circulating Biological Fluidized Reactor with the technology of fl

3、uid. It was separate into three areas, ascending area, descending area, deposition area. Wastewater and carrier were fluidized by air in ascending area, and wastewater was cleansed in ascending area and descending area. Water and sludge were separated in deposition area. The experimentation carrier

4、chooses porous foam. Its interspaces ratio is 90%,the proportion of area and volume is 2375m2/m3.It was fluidized easily because the density is heavier than water when animalcule grew on the carrier. When the foam was placed in the reactor, the consistency of sludge reached more 8000mg/L.It improved the cubage load to 12kgCOD/m3 d. The deposition area was designed into gradual section. It diminished velocity of liquid, sludge subsided and reflowed by the gravity and the suction of the recur