毕业设计--给水处理厂的设计
《毕业设计--给水处理厂的设计》由会员分享,可在线阅读,更多相关《毕业设计--给水处理厂的设计(69页珍藏版)》请在毕设资料网上搜索。
1、. . 摘 要 本设计主要是给水处理厂的设计,处理水量为 6 万立方米/天,该厂的水 源为地表水,水质情况良好,水库位于该城市给水处理厂东北方向,水厂位于 城市北面,原水水质其中的一些常规的检测项目符合生活饮用水水质卫生规 范(2001)的要求,需要处理的为水源的浊度、残渣及细菌的灭活。由于水 源水质良好无需预处理及深度处理,所以该水厂的处理工艺流程为常规处理工 艺。即:原水混凝沉淀过滤消毒用户。主要构筑物为:机械絮凝 池、斜管沉淀池、移动罩滤池和清水池。水厂布置采用了直角型,水厂地面标 高 22.00 米,服务水头 40-45 米。 关键词:给水厂;低浊度;工艺流程 . . ABSTRACT
2、 This design is the design of the main water treatment plants, water treatment for 60000 m 3 / day, the water surface water, water quality for good conditions, the city water supply plant reservoir located at northeast, north of the city waterworks, raw water quality and some of the conventional det
3、ection projects that comply with Life in the drinking water quality health standards (2001) requirement, Need to deal with water for the turbidity, residues and bacterial inactivated. Because the source good water quality and deep treatment without pretreatment, so the water treatment process for co
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中设计图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- 毕业设计 给水 处理 设计
