手动变速器毕业设计

《手动变速器毕业设计》由会员分享，可在线阅读，更多相关《手动变速器毕业设计（18页珍藏版）》请在毕设资料网上搜索。

1、 I 手动变速器设计 摘 要 变速器作为汽车的一个重要组成部分，是用来改变发动机传到驱动轮上的转矩和转速，目的是在原地起步、爬坡、转弯、加速等各种行驶工况下使汽车获得不同的牵引力和速度。 变速器有机械式手动变速器和机械式无级变速器两种，如果变速器挡位多其动力性和经济性得到保证，挡位少其操纵方便，本次设计我设计的是轻型货车变速器，本次设计中我对其传动比作了仔细的分析计算并参考相关车型最终确定了各挡的传动比，针对变速器的传动机构方案的布置作了详细的分析最终选用 5+1挡中间轴式变速器，换挡形式采用同步器换挡。结合总 体的要求操纵机构形式选用直接操纵机构形式。本次设计的变速器即满足了汽车必要的动力性

2、也满足了其经济性的指标。最后通过对齿轮、轴、键、轴承等的校核，其变速器的尺寸及其部件的强度都满足设计要求。 变速器的发展趋势是越来越复杂，自动化程度也越来越高，自动变速器将是未来的主流。 关键词： 变速器 ， 设计，轻型货车，传动比 II THE GENERAL DESIGHN OF TRANSMISSION ABSTRACT Transmission as an important component of car is used to change the engine reached the powerwheeles torque and rotational speed, in ord

3、er to get different power and speed in start, climbing, turning, accelerating, and other case of travel. Transmission has two styles of mechanical manule transmission and mechanical devices continues transmission, if the transmissions shift more its power and economic was guaranteed, if fewer its ma

4、nipulation is convenience, this design I design a light truck transmission, this design I determined the peed ratio after careful analys of peed ratio and ultimately the relevant type of the car, I made a careful analysis of the layout of the drive agency programmers against the transmission and fin

5、ally use the 5+1 block intermediate transmission, the form of shift use a synchronous device. After requested the overall the form of agencies use direct manipulation institutional forms. This designed of transmission meet the dynamic of the necessary power also meet its economic targets. Final adop

6、tion the degree of gear, axle, keys, bearings, etc. the size of transmission and strength of components are designed to meet the requirements. The development trend of the transmission is more complex, more and more is also high automation degree, automatic transmission is the mainstream of the future. KEY WORDS: Transmission, Design, light truck, Speed ratio.