中英文翻译--频谱分析在转子动平衡中的应用

《中英文翻译--频谱分析在转子动平衡中的应用》由会员分享，可在线阅读，更多相关《中英文翻译--频谱分析在转子动平衡中的应用（11页珍藏版）》请在毕设资料网上搜索。

1、中文 2420 字 本科毕业论文（设计） 相关中英文翻译资料 资料 题目： 频谱分析在转子动平衡中的应用 学生姓名： 所在院系：机电学院 所学专业：机电技术教育 指导老师： APPLICATION OF FREQUENCY SPECTRUM ANALYSIS IN THE ROTATOR MOVING EQUILIBRIUM ABSTRACT The experimental equipment is developed to simulate the rotator vibration. The running state of machine is simulated by using d

2、ifferent running conditions. The vibration caused by non-equilibrium mass is analyzed and discussed for first order with focus load. The effective method is found out by using frequency spectrum analysis. INTRODUCTION In the conventional island of nuclear power plant, turbine generator set is a very

3、 important equipment in which the core thermal energy is transferred into electric energy. When the turbine generator set has run for long time, the original equilibrium of system would be upset because of the remnant deformed of the metal, abrasion or damaging of the components etc. As a result, th

4、e vibration will be increased. So it is necessary to adjust the equilibrium at spot. On the other hand, a large turbine generator set also needs the work for adjusting the equilibrium in the process of manufacture, debugging, installation and operation. The moving equilibrium technique at spot is an

5、 important means to eliminate the violent vibration of the turbine generator set. We could have a definitely view for the vibration type, vibration power source and vibration property by analyzing the vibration of the turbine generator set or doing some special experiment. When the vibration signal

6、is obtained, the frequency spectrum could be used to analysis the vibration signal in order to diagnose quickly. Using frequency spectrum analysis, the electrical signal of vibration that is obtained by the vibration sensor and has a wide frequency range will be decomposed into several main frequenc

7、y compositions. Different frequency compositions have different influence on the turbine generator set. The frequency spectrum analysis is a very useful method to study the vibration of turbine generator set. The vibration caused by rotator mass non-equilibrium with concentrated load is discussed an

8、d analyzed in this paper. And an effective method to prevent the vibration is presented by using frequency spectrum analysis. 1 EXPERIMENTAL EQUIPMENT The experimental system consists of the motor, shaft coupling and rotor etc. Its structure is very simple. The rotor is driven by the motor directly.

9、 Its rotating speed could be adjusted in a wide range. The system could be operated smoothly and reliably. The rated current of the motor is 2.5 A, the output power is 250 W. The field excitation of the motor is provided by the 220 V AC power source which is commutated by the speed regulator, the ar

10、mature current of the motor is also provided by the same power source. It is adjusted by the compressor governor. Through adjusting the output voltage of compressor governor, the motor could be of step-less speed regulated at the range 0 10000 r/min, the rate of velocity increasing could be 800 r/mi

11、n. The length of the experimental equipment is 1200 mm, the width is 108 mm, the mass is about 45 kg, the diameter of the shaft is 9.5 mm, the length of the shaft is 500 mm and the maximum deflection is less than 0.005 0.015 mm. Any position along the axial direction could be selected as experimenta

12、l abutment point. The diameter and mass of the experimental rotating table is 7619 mm and 600 g, respectively. The arrangement of experimental equipment is shown in Fig.1. Fig. 1 The arrangement of experimental equipment The electrical vortex sensors are used to measure the relatively displacement o

13、r vibration for axis to bearing pedestal. They are installed in the x and y directions at the sensor support, respectively. They do not touch the shaft, and could be used to directly measure the vibration signal of the rotation shaft. The flashing phase-measurer is used to measure the rotator speed and the phase of the shaft. 2 THE FREQUENCY SPECTRUM ANALYSIS OF VIBRATION SIGNAL