芯棒冷却站旋转设备传动系统设计毕业设计

《芯棒冷却站旋转设备传动系统设计毕业设计》由会员分享，可在线阅读，更多相关《芯棒冷却站旋转设备传动系统设计毕业设计（50页珍藏版）》请在毕设资料网上搜索。

1、 I 本科生毕业设计说明书 学生姓名：XX 学 号：XXXXXX 专 业：机械设计及其自动化 班 级：机械 XX-X 指导教师：XXX II 摘摘 要要 随着限动芯棒连轧管机的飞速发展和国内外钢管需求的提高，钢管的产量 与日俱增，芯棒的用量也随之增加。芯棒工作后的温度升高，损耗不断的扩大， 增加了生产的成本，因此芯棒的维护也得到了很大的重视。由此，本文针对芯 棒的冷却系统提出了具体的设计方案，结合任务要求和冷却的基本理论，对三 个方案的工作原理和优缺点进行了细致的分析和比较，选择了第一种作为设计 的选定案。通过查阅相关资料，分析计算，确定电动机、减速器、轴、联轴器、 和键等重要零件的型号，并对

2、重点零件进行校核。在此基础上，再对系统的其 他非标准零部件，如：旋转上料器，移钢机等重要部件，进行结构的设计和计 算。按上述方法完成的设计能很好的完成芯棒旋转冷却的任务。 关键词：关键词：芯棒；冷却；钢管；方案 III Abstract With the rapid development of MPM and the improvement of demand for steel pipe at home and abroad, the output of steel pipe is steadily on the increase, and the amount of Mandrill i

3、ncreases. the temperature of the Mandrill increases after working along with the unceasing unceasing expansion of wear and tear,so the production cost has been increased.Because of it,much attention has been paid to the maintenance. This paper proposes the concrete design, in view of the cooling sys

4、tem of Mandrill. According to the requirements and the fundamental principle of cooling system, the paper chose the first as a selection of the design, by a detailed analysis and comparison of working principle ,as well as advantages and disadvantages of the three proposals. Through consultancy to relevant materials, analysis and calculation the paper determines the model of motors, reducers, shaft, coupling, keys, and other important parts,and checks up the important parts. On this basis, th