飞机用小制件注塑模具毕业设计

《飞机用小制件注塑模具毕业设计》由会员分享，可在线阅读，更多相关《飞机用小制件注塑模具毕业设计（46页珍藏版）》请在毕设资料网上搜索。

1、 I 飞机用小塑件模具设计 摘要 本文说明了 飞机用小制件 制件设计及塑料模具设计的全过程。制件、模具零部件造型全部用 pro/e 软件完成。在对制件分析的基础上完成了方案的选择，工艺及尺寸计算，完成了模具零部件装配，同时考虑了零部件的加工。设计中加入嵌件，斜滑 块 等模具特有的一些结构。 模具分为 一次 分型，分别在中间板上下面进行分型。 动 模 侧 的 内凹部分靠斜 顶杆 来完成，当斜滑杆充当顶杆向上推出塑件时，由于斜度的作用，斜滑杆同时水平方向平移一个距离，即为侧向抽芯距， 另一方面可以起到顶杆的作用， 它们用来完成零件 侧 部的 凹 孔。 关键词 : 塑料模具； pro/e 标准件；侧

2、向抽芯；性能尺寸 陕西科技大学毕业设计说明书 II Based on pro / e of the aircraft with a small plastic mold design Abstract This article describes the design of remote control and plastic rear cover parts of the whole process of mold design. Parts, mold parts and components of all shapes with pro / e software. Of parts ba

3、sed on the analysis of the choice of the completion of the program, technology and size, the complete assembly of the mold parts, at the same time taking into account the processing components. Insert to add the design of inclined slider and so on some of the unique structure of mold. Mold is divide

4、d into two sub-type, respectively, carried out in the middle of typing the following on the board. Typing out the first condensate is expected. The second type of plastic pieces in the completion of the side hole at the bottom of the top of the plastic parts at the same time. Dynamic part of the sid

5、e by the concave ramp to complete the push-rod, when the slider ramp up to serve as the introduction of plastic parts and push-rod, because the role of gradient, ramps slider at the same time a shift away from the horizontal direction, that is, core-pulling away from the lateral On the other hand, can play the role of push-rod, and they used to complete parts of the concave side hole. Keywords: plastic mold； pro/e Standard Parts； Side-core machine； Performance Dimensions