外文翻译----基于混合信号的数据采集卡的虚拟示波器

《外文翻译----基于混合信号的数据采集卡的虚拟示波器》由会员分享，可在线阅读，更多相关《外文翻译----基于混合信号的数据采集卡的虚拟示波器（22页珍藏版）》请在毕设资料网上搜索。

1、PDF外文：http:/ (2008) 103210391  外文 文献  A DAQ card based mixed signal virtual oscmoscope Abstract     Complex signals find many applications in SONAR, RADAR， Echo Location Systems and for studying the resonant frequencies. Digital Storage Oscilloscopcs(DSO) is used these days for a

2、cquisition and display of routine signals. This instrument, found in every measurement laboratory, though potent in displaying simple periodic waveforms like sinusoids fails when  frequency-varying time signals are applied, This problem surfaces because the underlying technique of oscilloscope

3、used to trigger the waveform does not acquiesce with complex signals like chirp. Ready solution to this problem is the mixed signal oscilloscope. This is a costly solution and small laboratories cannot afford to have the costly instruments. In this paper, a cost effective DAQ card based mixed signal

4、 virtual 0scilloscope is proposed to study the complex signals. An intelligent technique, Weighted Hamming Distance (WHD) algorithm was used to accurately trigger the complex waveforms. Also for frequency domain analysis, Joint Time Frequency Analysis(JTFA) techniques were used. A LabVlEW'TM bas

5、ed virtual instrument was designed and developed with a capability to acquire, display and analyze the triggered signal. The integrated programming language LabVIEWTM was chosen as it offers many simple ready to use functions. In a way the proposal offers a cost effective, fast and flexible solution

6、 to treat the complex signals. The need to create such solutions is the consequence of costly hardware systems. The deficiency of conventional hardware. Scheme for the virtual oscilloscope for complex signals with some real time experimental results are presented in this work. Kevywords: Virtual ins

7、trumentation,Chirp signal,Data acquisition,Triggering, Complex signals, JTFA 1.Introduction    For the last two decades there has been a tremendous progress in computer technology. Measurement domain is no longer left unaffected. The way measurements are being done is totally revolutionize

8、d. Computer based measurement or say virtual instrumentation is gradually replacing the costly bench 2  top instrumentation as it offers flexible,fast and cost effective solutions. Various classical instrumentation systems namely Oscilloscope, Multimeters and Spectrum analyzers ect. are almost

9、 phased out by their counter part virtual instrumentation. Our research extends the trend and demonstrates the developmen of the computer based mixed signal digital oscilloscope.    Conventional signals such as the sinusoids have a constant frequency and the amplitede only varies with

10、 time throughout the signal definition. On the other hand, complex signals can be defined in this context as signals in which all the parameters vary. Fig.1 shows a typical complex signal i.e. Linear Chirp.    Variation of amplitude and frequency with time can easily be understood by havin

11、g a look at the signal. This requires a visually stable display of signal. The complex signal offers challenges f'or acquisition, display an analysis. Even the conventional modern age DSO is not capable of displaying and analyzing complex signals because these instruments employ simple triggerin

12、g technique like level trigger. The conventional technnique of voltage trigger apparently fails when complex signals like chirp are analyzed on DSO. This is due to the very fact that these instruments consider chirp as a conventional sine wave and trigger for each cycle of the sine wave instead of t

13、riggering for the complete chirp cycle. This analysis of the chirp signal as several sine waveforms of different frequencies leads the DSO to display them as sinusoids in quick succession. As this rapid change occues at a very high rate and because of human eye not registering events occurring faste

14、r than 1/20th of a second the display appears as several overlapped sine waves. In the recent work1, a new triggering technique was proposed for the complex signals based on WHD. Subsequent sections present the solution to the problem. For analysis of the complex signals in frequency domain JFFA tec

15、hnique is utilized and implemented2-6.   DSO uses the level trigger to display the waveform applied to it. This leads to trigger interval and the number of samples for this trigger interval is computed and these numbers of samples are display. The DSO considers the interval as the fundamental t

16、ime period of the whole waveform and thus takes tbat much samples from its buffer and starts displaying it in quick succession. With simple waveform like a sine wave, level trigger can achieve stable display because trigger interval contains same number of cycles. This is shown in Fig. 2a. 3