照明系统外文翻译

《照明系统外文翻译》由会员分享，可在线阅读，更多相关《照明系统外文翻译（16页珍藏版）》请在毕设资料网上搜索。

1、英文翻译 原文： ABSTRACT This paper discusses the implementation of semi-permanent, high-mast pole-mounted lighting for nighttime road work construction and maintenance based on an installation along Interstate 90 in Albany, New York. The high-mast lighting system met state lighting performance specificati

2、ons. There were no recorded accidents at the site during the construction period. Although this is largely attributable to roadway closures allowed during part of the project, the consensus of the contractor and transportation agency is that the lighting contributed at least in part to an increase i

3、n safety. The cost of the high-mast lighting system was approximately 16% higher than the estimated cost of the portable light towers. Despite the higher estimated cost of the high-mast lighting system, the economic and societal benefits appear considerable in this particular location, namely an urb

4、an, heavily traveled throughway. In particular, this lighting approach probably allowed the duration of the construction period to be shortened, leading to a reduction in worker and driver risk exposures and to a reduction in traffic delays for motorists. An approach to identifying projects where th

5、is lighting technique might be warranted is presented. INTRODUCTION Semi-permanent, high-mast (70 ft.) pole-mounted fixtures were used by a construction contractor hired by the New York State Department of Transportation (NYSDOT) to illuminate nighttime road work construction and maintenance along a

6、 three-mile stretch of Interstate 90 (I-90) in Albany, N.Y., as an alternative to the more commonportable light towers (1). The high-mast lighting was installed prior to construction work and removed after the construction project was completed, about seven months later. Freyssinier et al. (2) docum

7、ented the high-mast lighting system and its performance in terms of photometric performance, visibility and glare. The high-mast lighting system was found to have performed well and as intended. The installation provided a level of illumination sufficient for performing the maintenance and construct

8、ion activities at the site (3), with less pronounced shadows and relatively low glare. The purpose of the present paper is to discuss approaches to identifying if and when this lighting approach can be appropriate for a highway construction project. Issues regarding safety, economics and environment

9、al impacts are discussed, and an approach to warranting semi-permanent, high-mast nighttime construction lighting is offered. To decide if and when semi-permanent high-mast lighting is feasible for highway construction work, one must consider safety, economics and environmental impacts. These issues

10、 are discussed, in turn, in the following sections. SAFETY Crash Risk Factor When the contractor hired by NYSDOT to perform road work along I-90 proposed using semi-permanent, high-maslighting for nighttime construction work, safety engineers analyzed the proposal against the concern that most (abou

11、two-thirds) of the proposed high masts would be located within the 30 ft clear zone desired for this highway. The clear zone is defined (4) as the area outside the paved roadway area where a vehicle could safely travel if it left the road. Acknowledging that portable lighting for nighttime roadway c

12、onstruction work is nearly always located withinthe clear zone and in fact often closer to drivers, NYSDOT engineers concluded that high-mast lighting probably had a lower risk factor than portable light towers, and authorized the contractor to proceed with the installation and roadwork, based on th

13、e following reasons: While in use, portable light plants are almost always located inside the clear zone. About one third of the 108 high-mast poles proposed could be located outside the clear zone without compromising lighting quality. The lower number of poles in the clear zone, compared to the nu

14、mber of conventional, portable units needed to illuminate a portion of the highway, was thought to weigh against the added risk of drivers! constant exposure to semi-permanent poles during both daytime and nighttime. Howeveradditional safety features were recommended, such as traffic barriers, guard

15、s and crash cushions. High-mast poles avoid the high-risk exposure of workers every night during setup and removal of the conventional portable light units. In the I-90 project, it was estimated that at least 8250 worker-hours of high-exposure would be eliminated. Time savings in the mobilization of

16、 portable lights meant night construction could be completed in 222 days rather than 275, reducing the work to one construction season. NYSDOT! s authorization was conditioned on tremoval of the high-mast poles by winter shutdown, regardless of the contractor! s work accomplishments. Worker Safety I

17、mplications While the conventional light towers are extremely useful because of their portable nature, there are a number of known issues regarding the difficulty of their installation, operation, and maintenance. First, there are a large number of warnings associated with most products (during setu

18、p, operation, maintenance, stowing, and transportation). Second, the two main risks associated with the use of portable light towers are the interaction of workers with traffic during setup and removal when both conditions represent a high risk of collision between workers and drivers, and the setup

19、 of light towers near power lines. Although there are no published statistics, it is reasonable to believe that crews are at increased risk of injury or fatality when raising a mast near power lines. It follows that by having a semi-permanent lighting installation, much of the risk mentioned would n

20、ot be present. TABLE 1 Estimated Operational Cost of PortableLightTower Installation Estimated number of portable light towers required 120* Daily setup and removal cost Number of crew members in charge of setup and removal 10 Estimated number of hours to setup and remove light towers, per night 3 T

21、otal worker hours per night 30 Estimated cost per hour (base rate + benefits + overhead & profit) $40 Total setup and removal cost per night $1,200 Daily operational cost Hourly operational cost per light tower (fuel, oil, regular maintenance, etc.) $3.60 Estimated daily cost per light tower ( 6 hou

22、rs per night) $21.60 Daily rental cost ( $990 per month rent) $33 Total operational cost per night (assuming contractor owns 100 towers and rents 20) $3,252 Total cost per night (setup, removal, and operation) $4,452 Estimated duration of project in days 275* Total cost to provide lighting with 120

23、portable light towers $ 1,224,300 120 towers is estimated to be required to illuminate a sufficient portion of the work zone at one time. The duration was estimated to be 40 days shorter using the high-mast system. Another potential safety benefit of high-mast lighting that could not be quantified p

24、recisely was the fact that warning signs, signals, and other materials for guiding traffic through the work zone could be set up each night under lighted conditions. In comparison, such warnings are typically set up by workers in advance of having the conventional light towers operational. The Envir

25、onmental Protection Agency recommends a maximum noise level of 75 dBA in work environments for hearing conservation (5). Though the generators that power most of the commercial light towers typically have a noise level rating of 71 dBA, the large number of light towers (each with its own generator) and their relatively close spacing (typically about 100 ft between units) can cause noise to add up to levels that could be more than the maximum recommended. During this project, five large