2014年热冲压外文翻译--热冲压圆柱形深拉延性的改善

《2014年热冲压外文翻译--热冲压圆柱形深拉延性的改善》由会员分享，可在线阅读，更多相关《2014年热冲压外文翻译--热冲压圆柱形深拉延性的改善（13页珍藏版）》请在毕设资料网上搜索。

1、2100 英文单词，英文单词，1.1 万英文字符万英文字符，中文中文 3150 字字 文献出处：文献出处：Kusumi K, Nomura N, Yamamoto S, et al. Improvement of cylindrical deep drawability in hot stampingJ. Procedia engineering, 2014, 81: 1719-1724. Improvement of cylindrical deep drawability in hot stamping Kazuhisa Kusumi, Naruhiko Nomura, Shuji Yam

2、amoto, Masahiro Nakata,Masayuki Abe, Masahiro Suehiro Abstract Deep drawability of steel sheets in hot stamping was investigated. In the case of deep drawing with a conventional die, the forming limit was significantly lower because the temperature of the sheet metal at the flange part decreased dur

3、ing the forming and the flow resistance increased. Therefore, the blank holding method to avoid temperature decrease at flange part of sheet metal was studied. In this study, application of gap supports and forming without blank holder were investigated. In the former method, the gap supports made c

4、learance at the flange part. In the latter method, the blank holder was located at the lower dead point from the beginning of forming and the flange part of the blank was free during forming. The forming limit in both cases was improved as compared with that in the conventional blank holding method. For the application of gap supports, the limiting drawing ratio was also evaluated. In this experiment, the maximum value of limiting drawing ratio was 1.71. Keywords: Sheet metal forming; Ho