基于单片机毕业外文文献翻译--AT89S52单片机应用

《基于单片机毕业外文文献翻译--AT89S52单片机应用》由会员分享，可在线阅读，更多相关《基于单片机毕业外文文献翻译--AT89S52单片机应用（15页珍藏版）》请在毕设资料网上搜索。

1、 本科毕业设计（论文） AT89S52 单片机应用中英文翻译 专业名称： 电气工程及其自动化 年级班级： 学生姓名： 指导老师： 二二 O 一七一七年六月九日年六月九日 1 AT89S52 MCU Applications Function Characteristic Description The AT89S52 is a low-power, high-performance CMOS 8-bit microcontroller with 8K bytes of in-system programmable Flash memory. The device is manufactured

2、 using Atmels high-density nonvolatile memory technology and is compatible with the indus-try-standard 80C51 instruction set and pinout. The on-chip Flash allows the program memory to be reprogrammed in-system or by a conventional nonvolatile memory pro-grammer. By combining a versatile 8-bit CPU wi

3、th in-system programmable Flash on a monolithic chip, the Atmel AT89S52 is a powerful microcontroller which provides a highly-flexible and cost-effective solution to many embedded control applications.The AT89S52 provides the following standard features: 8K bytes of Flash, 256 bytes of RAM, 32 I/O l

4、ines, Watchdog timer, two data pointers, three 16-bit timer/counters, a six-vector two-level interrupt architecture, a full duplex serial port, on-chip oscillator, and clock circuitry. In addition, the AT89S52 is designed with static logic for operation down to zero frequency and supports two softwa

5、re selectable power saving modes. The Idle Mode stops the CPU while allowing the RAM, timer/counters, serial port, and interrupt system to continue functioning. The Power-down mode saves the RAM con-tents but freezes the oscillator, disabling all other chip functions until the next interrupt or hard

6、ware reset. Pin Description VCC ：Supply voltage. GND ：Ground. Port 0：Port 0 is an 8-bit open drain bidirectional I/O port. As an output port, each pin can sink eight TTL inputs. When 1s are written to port 0 pins, the pins can be used as high-impedance inputs. Port 0 can also be configured to be the multiplexed low-order address/data bus during accesses to external program and data memory. In this mode, P0 has internal pull-ups. Port 0 also receives the code by