毕业论文--三角定位片的冲压工艺与模具设计
《毕业论文--三角定位片的冲压工艺与模具设计》由会员分享,可在线阅读,更多相关《毕业论文--三角定位片的冲压工艺与模具设计(40页珍藏版)》请在毕设资料网上搜索。
1、 本科毕业设计说明书 题 目:三角定位片的冲压工艺 与模具设计 院 (部) : 机电工程学院 专 业: 机械工程及自动化 班 级: 机械 104 班 II 目目 录录 摘 要 本课题研究的是三角定位片的冲压工艺与模具设计,通过对制件零件图的分析,确 定了毛坯尺寸和排样方式以及工艺方案.最终确定该工件的加工工序由两套模具分两步 来完成,分别是落料拉伸复合模,冲孔模。计算了各工序所需压力,选用了压力机; 在计算的基础上设计模具的具体结构,选用了标准件并且设计零部件。最后在计算机上 应用 CAD 软件画出装配图和零件图,制订工艺卡片,形成一套比较完整的可用于指导生 产的技术文件。设计过程参考各种技术
2、标准和各种资料。 关键词:三角定位片;冲压模具;工艺分析和模具设计 ABSTRACT This research is the stamping process and die design triangulation piece, through the parts parts diagram analysis to determine the rough size and nesting methods and technology program. Finalize the workpiece machining process in two steps by the two sets
3、of molds to accomplish, namely blanking - drawing compound die, punching die. Calculate the various processes required pressure, the choice of the press; calculated on the basis of the specific structure of the design of the mold, the choice of standard parts and design components. Finally, the appl
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中设计图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- 毕业论文 三角 定位 冲压 工艺 模具设计
