欢迎来到毕设资料网! | 帮助中心 毕设资料交流与分享平台
毕设资料网
全部分类
  • 毕业设计>
  • 毕业论文>
  • 外文翻译>
  • 课程设计>
  • 实习报告>
  • 相关资料>
  • ImageVerifierCode 换一换
    首页 毕设资料网 > 资源分类 > DOC文档下载
    分享到微信 分享到微博 分享到QQ空间

    土木工程道路毕业设计--二级公路初步设计

    • 资源ID:122372       资源大小:1.59MB        全文页数:85页
    • 资源格式: DOC        下载积分:100金币
    快捷下载 游客一键下载
    账号登录下载
    三方登录下载: QQ登录
    下载资源需要100金币
    邮箱/手机:
    温馨提示:
    快捷下载时,用户名和密码都是您填写的邮箱或者手机号,方便查询和重复下载(系统自动生成)。
    如填写123,账号就是123,密码也是123。
    支付方式: 支付宝   
    验证码:   换一换

     
    账号:
    密码:
    验证码:   换一换
      忘记密码?
        
    友情提示
    2、PDF文件下载后,可能会被浏览器默认打开,此种情况可以点击浏览器菜单,保存网页到桌面,就可以正常下载了。
    3、本站不支持迅雷下载,请使用电脑自带的IE浏览器,或者360浏览器、谷歌浏览器下载即可。
    4、本站资源下载后的文档和图纸-无水印,预览文档经过压缩,下载后原文更清晰。

    土木工程道路毕业设计--二级公路初步设计

    1、 长沙学院 毕业设计 (论文 ) I 摘 要 本设计是湖南省龙山至永顺二级公路初步设计,路段地处丘陵区,沿路地形起伏在 400 600m 之间,路线起止桩号从 K4+000.000 至 K7+006,该公路的主要技术指标为路基宽度 8.5m,双向双车道,无中央分隔带,设计车速 60km/h。本次设计的是二级公路的初步设计,首先进行了地形图的研究,在熟悉地形图之后,查阅了当地相关的地形地质,水文气候条件,拟定了两条路线比选方案,在经过比较技术指标及经济指标后,最终选择最佳方案。在路线的平面设计之后,进行了纵横断组合设计、路基设计、路面设计。在路基路面设计完 成之后,路基设计专项中的挡土墙设计以及

    2、路基路面排水的设计。挡土墙采用的是重力式挡土墙,排水防护设计进行了边沟、排水沟以及截水沟的组合形式。然后进行了涵洞以及平面交叉设计,本路线需要构造两处涵洞,采用圆管涵形式,交叉口采用加铺转角式。最后对进行了工程的概预算,利用纵横概预算软件计算,概算金额为 11439135 元。 关键词 : 湖南,龙山,永顺,二级公路,初步设计 长沙学院 毕业设计 (论文 ) II ABSTRACT The design of Hunan province Longshan to Yongshun two road sections in the preliminary design, the basin, b

    3、asin surrounded by mountains surrounded by, its elevation in 400 600 meters between. The two stage highway begins to pile No. K4+000, end pile No. K7+006.The main technical indexes for highway roadbed width 8.5m, a two-way dual carriageway, without the central dividing strip. The design of the speed

    4、60km/h. This design is the two highway preliminary design, first carried out the study on topographical map, in a familiar terrain map, access to the local topography and geology, hydrology and climate conditions. The initial formulation of the two route alternatives, after comparison of technical i

    5、ndicators and the actual engineering situation, the final choice of relatively suitable scheme. In the course of graphic design, proceed with the longitudinal design, cross-sectional design, roadbed design, roadbed design is complete, start a pavement design, considering the actual situation of the

    6、project, finally decided to take the road design of cement concrete pavement. In the design of roadbed and road surface is completed, a retaining wall and drainage and protection design. The retaining wall is used in gravity retaining wall, drainage and protection design for the side ditch drainage

    7、ditches and drainage design. After conducting a culvert and the intersection of the plane of the preliminary design, the route need to construct two culverts, using pipe culvert form,Intersection using overlay corner . At the end of the project budget, project budgetary estimate, according to the actual situation, using aspect software over the budget, budget amount of 11439135 yuan. Keywords:Hunan,Longshan,Yongshun,two highway,preliminary design


    注意事项

    本文(土木工程道路毕业设计--二级公路初步设计)为本站会员(泛舟)主动上传,毕设资料网仅提供信息存储空间,仅对用户上传内容的表现方式做保护处理,对上载内容本身不做任何修改或编辑。 若此文所含内容侵犯了您的版权或隐私,请联系网站客服QQ:540560583,我们立即给予删除!




    关于我们 - 网站声明 - 网站地图 - 资源地图 - 友情链接 - 网站客服 - 联系我们
    本站所有资料均属于原创者所有,仅提供参考和学习交流之用,请勿用做其他用途,转载必究!如有侵犯您的权利请联系本站,一经查实我们会立即删除相关内容!
    copyright@ 2008-2025 毕设资料网所有
    联系QQ:540560583